IT equipment safety (IEC 60950-1)
Scope, test items, common findings and certification routes.
IEC 60950-1 — safety of information technology equipment
IEC 60950-1 is the safety standard for information technology equipment, covering mains-connected IT equipment and its accessories. Note that IEC 60950-1 has been superseded by IEC 62368-1 in most markets; a 60950-1 report is still useful for legacy products, for markets that have not migrated, and as the basis for a 62368-1 gap upgrade. We test to 60950-1 and can carry the same sample over to a 62368-1 evaluation.
Products covered
Information technology equipment and its power supplies, including equipment powered from the mains or from a remote supply.
Main test items
- Marking, instructions and language requirements
- Input current, power and rating verification
- Temperature rise at normal load and at the declared maximum load
- Electric strength (hipot), insulation resistance and insulation coordination
- Touch current / leakage current measurement
- Clearance, creepage distance and insulation distances on PCB and transformer
- Fire enclosure, flammability of materials and openings
- Mechanical strength, impact, stability and wall-mount strength
- Moisture treatment followed by electric strength
- Abnormal operation and single-fault conditions (component short / open)
- Capacitor discharge, earth continuity and protective bonding
- Construction of transformers, optocouplers and other critical components
Common reasons a sample is rejected
| Finding | Why it fails |
|---|---|
| Clearance / creepage short on the primary side | Slot routing and conformal coating are often counted as spacing when they do not qualify. |
| Transformer construction not to the required insulation category | Margin tape width, triple insulation and winding order must match the declared insulation class. |
| Temperature rise above the limit | Small adapters running at full load, and output capacitors placed against the case. |
| Fire enclosure openings too large or material too flammable | Vent holes and bottom openings are measured against the fire-enclosure rules, not visual judgement. |
| Touch current above the limit | Y-capacitor selection and the discharge resistor network are the usual cause. |
| Single-fault test leads to smoke or flame | Protective devices and component ratings were not checked under short / open conditions. |
| Critical components without valid certification | X/Y capacitors, varistors, fuses and optocouplers must carry acceptable component approvals. |
| Marking or instructions incomplete | Model, input rating, caution marks and language set must match the target market. |
Certification routes
- CB Scheme — IECEE certificate and report on IEC 60950-1 (with -21 / -22 where telecom or telecom wiring applies)
- CE — Low Voltage Directive 2014/35/EU; for new designs the harmonised route is now EN IEC 62368-1
- North America and China — new listings generally require the 62368-1 equivalent (UL/CSA 62368-1, GB 4943.1); 60950-1 reports are kept for legacy models and existing certifications
Sample and timing
Samples: 2 to 3 production units, plus the critical component list with their approvals, transformer drawings and PCB layout. Lead time is confirmed after the output configuration and the target market are fixed; if the market has migrated to 62368-1, we quote the gap assessment in the same run.
LCS TESTING LAB · Electrical & lighting
Inquiry / Request a quote
Tell us what you need, we reply within 24 hours.

One-stop testing and certification for ESS and lithium batteries — UN38.3, IEC 62619, CE, UL, FCC and more.
Contact
+86 177 2252 2312- sunny-a.lcs@powcert.com
- Juji Industrial Park, Shajing, Bao'an District, Shenzhen, China